Slash Stuff

[DustinH]

Is anybody removing the bullet connectors and direct soldering the ESC wires to the motor? Is it worth it?

[pup1970]

I would keep the connectors, but put a drop of solder on each one. If you are not fealing heat on them after you run, you probably are not loosing any power, but keep the connectors so you can say that your car is still legal.

[mastangs64501]

I put deans between the motor and esc after the stock bullet conectors burned up

[DeadLastRacing]

i hard wired mine

[lil_man72]

Is anybody removing the bullet connectors and direct soldering the ESC wires to the motor? Is it worth it?

i don't think they care at fastlane. i still have mine, but i'm thinking about hardwiring them.

[PitDaddy]

Deans plugs just because I didn't like the cheesey bullet connectors.

[Smokinjoe]

I read somewhere if you turn the ESC 180 degrees the wires will reach the motor to connect directly but its tight.

[M.Gardner]

Yea, i heard that too, but i cut the connectors of and it was way too short to direct solder them even if you turned the ESC around. I just soldered them together, works fine.

[vxl_racer]

i did this to my slash
http://img.photobucket.com/albums/v696/smitty_303/myPictures036.jpg

[DustinH]

That should give it a little more power, lol!

[vxl_racer]

that it does if i punch it coming through the yard and onto the street it will ride down the street on the rear bumper